Süsswassertang Wall

Finally I have enough suswassertang to try and make a wall for my 110g. Its been pilling up in my tank and laying waste to carpet plants.
I pulled out enough to fill my babys bath now all I need to do is figure out what to use to make the wall. I'm thinking something with around 5mm to 10mm holes.
Any tips or hints

Forgot a pic of it all and there's still more in my tanks

 

Gratis Verzending 2.8x2.8 inch Gaas voor Mossen Aquarium Planten in Gratis Verzending 2.8x2.8 inch Gaas voor Mossen Aquarium Planten van Decoraties op AliExpress

My tanks 150cm long and 50cm high not including the substrate so they are a bit small. I might be able to get some plastic chicken wire I was thinking might do the trick and do 3 50x50cm pannels. But I think the holes are too big

 

Look at Alie Express for all kind of sizes

My tanks 150cm long and 50cm high not including the substrate so they are a bit small. I might be able to get some plastic chicken wire I was thinking might do the trick and do 3 50x50cm pannels. But I think the holes are too big

Didn't mean this specific one !

 

Look at Alie Express for all kind of sizes

Didn't mean this specific one !

I was thinking I could sew it between 2 sheets of plastic mesh so it could grow out the holes and between the 2. I'm not sure which way would be easier. If I tie it to a single piece will it still spread or only grow out.

 

When I was making mine for my 29, I just laid down a sheet the size of my back wall, then laid all the süsswassertang on it then put another screen on. Then just weaves string through the outer edges. It just grew straight through the wcreen

 

When I was making mine for my 29, I just laid down a sheet the size of my back wall, then laid all the süsswassertang on it then put another screen on. Then just weaves string through the outer edges. It just grew straight through the wcreen

What size holes did your screen have or does it not matter.

 

I used door screen actually. I probably should of gone bigger and it took a while but it worked

 

I used door screen actually. I probably should of gone bigger and it took a while but it worked

How long did it take to grow through.
Any pics

 

I will when I get home from vacation. It took approximately 2 months to get all screen covered. Tank has fertz, high bioload, and strong lighting

 

I will when I get home from vacation. It took approximately 2 months to get all screen covered. Tank has fertz, high bioload, and strong lighting

My tanks the same but with pressurized co2 and a lower bioload. 2 months isn't bad its taken who knows how long to grow all this. I started with a srap bit that came with some shrimp