911

Discussion in 'Filters and Filtration' started by redlessi, Dec 4, 2009.

  1. redlessi

    redlessiWell Known MemberMember

    Just unplugged my aquaclear 150 for a water change and when I plugged it back in it did nothing:;dk:;dk:;dk:;dk No sound no nothing, what can I do until tomorrow when I can buy something else if I need to?????????????
     
  2. harpua2002

    harpua2002Fishlore VIPMember

    Unplug your filter again and take it apart. Remove the pump and impeller and clean, clean, clean (you can float the media in a bucket of tank water until you're done). Make sure there aren't grains of sand or plant matter or anything around the impeller. It should work when you put it back together. :)
     
  3. AlyeskaGirlFishlore VIPMember

    Don't panic, mine do that sometimes. I just take it back off and mess with the impeller. Did you clean the impeller?
     
  4. OP
    OP
    redlessi

    redlessiWell Known MemberMember

    Thanks much for such a speedy response I will try now.................
     
  5. btate617

    btate617Well Known MemberMember

    when I used them they did that to me too.
    Sounds like something is just stuck, keep messing with it.


    Brian
     
  6. AlyeskaGirlFishlore VIPMember

    Your welcome. Oh, for the inside of the pump when you pull the impeller out I use q-tips to get the gunk out if you don't have a small narrow brush. Then poor water in a few times and dump in out to get the loosend gunk out.
     
  7. OP
    OP
    redlessi

    redlessiWell Known MemberMember

    You are the best, it works, it works.............I love this place:;group
     




  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice