3d Printed 4" Riser For Finnex 24/7 Design Ver. 1.0

TinyWhoop

Valued Member
Messages
53
Reaction score
5
Points
43
Experience
Just started
I am designing a riser for my new Finnex Planted+ 24/7 LED light.
Any comments?
If i have time, I might add little fancy stuffs like, may be "Fishlore Fan" indent wordings.
I will trial print it tonight and share the 3D file here if everything goes well.

Finnex 24.7 Raiser 4 inch back.jpg Finnex 24.7 Raiser 4 inch.jpg Finnex 24.7 Raiser 4 inch side.jpg Finnex 24.7 Raiser 4 inch front.jpg Finnex 24.7 Raiser 4 inch side 2.jpg
 
  • Thread starter
  • Thread Starter
  • #3

TinyWhoop

Valued Member
Messages
53
Reaction score
5
Points
43
Experience
Just started
It fits perfectly, just need a little fine tune on the excessive thickness.
95B9383B-487F-4FB1-9572-4DD6A2099856.jpeg 6004BFCA-ABF2-446E-B128-E373907363D6.jpeg AC470516-9912-4E92-B23B-C2134F9182C3.jpeg
 
  • Thread starter
  • Thread Starter
  • #4

TinyWhoop

Valued Member
Messages
53
Reaction score
5
Points
43
Experience
Just started
Done. The final version fits perfectly and works better than I expected. I added an inner bracket and it’s now even more secure on the frame than the original stand. No way it can slide off the frame sideways.

9C4204BD-1E7E-4C93-A02E-6CE62D723203.jpeg 0CF58C2E-98E2-40B4-9D75-2F1035D084F7.jpeg 4F96EBE1-C427-41E2-9CE5-C19C973E32D7.jpeg 216A118D-C677-48DC-B363-37E8594F59B7.jpeg
 
Toggle Sidebar

Aquarium Calculator

Follow FishLore!





Top Bottom